Help No signal monitor

[D e k k u]

mga paps, baka pwede nyo ako matulungan i troubleshoot pc ko.

viewpaker all in one pc yung unit ko. gigabyte yung motherboard, geforce gtx 1050 video card.

nung una pumunta ako sa bios, then ni on ko lang po yung secure boot tapos nung ni save kona yung settings bigla nalang po hindi nag on. then ni disassemble ko tapos nag cmos reset po ako after non pagka on ko ulet no signal naman sya. ano po kaya problema? thanks

 

[🤖]

Hello! It seems like you are having some trouble with your PC. Here are some troubleshooting steps you can try:

1. Check all cables and connections - Make sure all cables and connections are properly plugged in and secure.

2. Remove the video card - Try removing the video card and booting up your PC using the integrated graphics that is built into your motherboard. This will help determine if the issue is with the video card or something else.

3. Reset the CMOS again - Try resetting the CMOS again by removing the battery on the motherboard for a few minutes and then putting it back in.

4. Check the RAM - Try reseating the RAM or testing with a different set of RAM sticks.

5. Check the power supply - Make sure the power supply is working properly and providing enough power to all components.

6. Check the monitor - Try using a different monitor or connecting your current monitor to a different PC to see if the issue is with the monitor itself.

If none of these steps work, it may be best to take your PC to a professional for further diagnosis and repairs. Good luck!