Official thread: wimax problem and mac address

[sniper76]

Ok try ko mamaya yan boss lift then post ko a agad resulta! 
Sir Lift.. eto po yung resulta ng arp -a

 

[Senpai]

aw, 169 ip ka hanap ako solusyon teka

 

[Senpai]

bm622m 2012 ba yan? 169 ip ka, ganito gawin mo, cmd ipconfig /flushdns tapos ipconfig /release then ipconfig /renew pag di gumana mag static ip ka, set mo sa adapter mo sa 1pv4, ip 192.168.254.2 tas default gateway 192.168.254.1 okay,then try mo disbale enable si adapter mo, if di magwork, Reflash mo nalang si bm622m if mareflash mo na bigyan kita ng command para marenew ulit si gui nya,

 

[sniper76]

Ok sige try ko sir!... update kita agad for the result!

 

[sniper76]

Sir Lift eto po yung mga steps na ginawa ko.. open cmd > ipconfig /flushdns > ipconfig /release > ipconfig /renew ganun pa din sir, di ko pa din ma-access yung gui.. tapos next step.. set static ip > ipv4 192.168.254.2 subnet 255.255.255.0 default gateway 192.168.254.1 after setting disable then enabled adapter.. same result bossing.. then I downloaded WinSpreader along with firmwares for BM622m kaso ayaw kumagat!, I mean hinihintay ko mag-disco lights yung mga ilaw naka-ilang hugot saksak din ako pero ayaw pa din! gggrrrrrrr.. nakakagigil :devil:

 

[Senpai]

ganan talaga, nangyari na sakin ang disco light na di manlang nakagat, mag static ip ka habang nagrereflash to dv firmware

 

[sniper76]

ok try ko ulit!.. hehehe muntik ko na maihagis sa bintana eh hahaha!

 

[Rashie15]

gud day po. mga boss pwde po ba ako mkahingi ng mac?

622i 2010.

thanks in adv.

 

[sniper76]

Sir lift ayaw talaga mukhang kailangat na ng technician nito! ;-)

 

[imbz]

Sir lift ayaw talaga mukhang kailangat na ng technician nito! ;-)

Anu ba sira niyan ?

 

[sniper76]

Na-remote po yata sir Imbz, kasi na disconnect sya after a few days of using mac address na napulot ko dito.. tapos biglang na-disconnect di ko na po ma-access yung gui using 192.168.254.1 pag nag-ip config naman po ako walang default gateway nag-try na din po akong mag set ng static ip as instructed by sir lift pero wala pa din.. I also did some research on how to flash firmware.. I used winspreader followed the susok-bunot procedure.. pero wala pa din! hhaayyy

 

[imbz]

Na-remote po yata sir Imbz, kasi na disconnect sya after a few days of using mac address na napulot ko dito.. tapos biglang na-disconnect di ko na po ma-access yung gui using 192.168.254.1 pag nag-ip config naman po ako walang default gateway nag-try na din po akong mag set ng static ip as instructed by sir lift pero wala pa din.. I also did some research on how to flash firmware.. I used winspreader followed the susok-bunot procedure.. pero wala pa din! hhaayyy

pm mu ako baka matulungan kita

 

[karlayeen]

me katanungan po ako mga bossing itong ox230 ba pwedeng i inject sa dv235t corious lang ako sa firmware ng ox230

same same lang yan firmware ox at dv

 

[Senpai]

Na-remote po yata sir Imbz, kasi na disconnect sya after a few days of using mac address na napulot ko dito.. tapos biglang na-disconnect di ko na po ma-access yung gui using 192.168.254.1 pag nag-ip config naman po ako walang default gateway nag-try na din po akong mag set ng static ip as instructed by sir lift pero wala pa din.. I also did some research on how to flash firmware.. I used winspreader followed the susok-bunot procedure.. pero wala pa din! hhaayyy

nag flash kana ba to dv then balik sa bm622m 2012 firmware? baka kase unsuccessful ang flashing mo,

 

[Senpai]

if naka flash kana sa dv, reflash ka ulit to 622m 2012 open gui 192.168,254,1 log in as user, then type this to your browser 192.168.254.1/advanced/acl.html check mo si telnet press Shift + alt +a then check si SSH, then open putty, type 192.168.254.1 port 22 SSH log in as mt7109 pass:wimax

then use this command


apinfo > /etc/default.cfg

sncfg commit

sncfg reset

sncfg default

reboot

*note open ka cmd, lagi mo iccheck ang ip mo kung pumasok si flash mo,
di ako maari magkamali, dito sana tama flashing mo, kung mali,wala talaga mangyayari dyanafter neto, open mo si web gui,log in as user muna, kunin serial at master mac at ienerate ang admin password, via genpasstool by squashfs666, log in as admin, then advanced>acl> enable telnet.

 

[akosijj]

sir

Corrupted Gui, pag binuksan mo ang gui nya blanko ang wan address

sir baka po pwedeng patulong pano ma ayos ang blackwan blanko na yung wan ng modem ko bm622 2009 version

 

[mguiams]

Pa

youre welcome pre pm lang kung me problem pa

Patulong boss panu marecconect bm621

 

[Obione]

Pa


Patulong boss panu marecconect bm621

ok add me sa fg pakilala ka lang pag wala problem 621 mu madaling marereconnect yan
You do not have permission to view the full content of this post. Log in or register now.

 

[xspeices09]

pa bookmark

 

[akosijj]

pwede pa tulong ayaw na mag conect sa telnet 192.168.1.1 yung modem ko 2011...maysulosyon pa ba dito samalat mga sir..