Type control port_fw_eligiblity_switch disable and press Enter (no that’s not a typo in the word eligiblity!)
Done. Close the command prompt window."
Up to there is great but there is one command missing.
Switch back to the Config#
and then type "save"
it will write the changes just made to flash, thereby saving it. That way when the router powers off and then powers on again the config will be intact. No need to go in and change it every time the router power cycles.
Turn off TR069 protocol in all the places where it's enabled so the router can't be accessed remotely by PLDT's TR069 protocol servers.
Type control port_fw_eligiblity_switch disable and press Enter (no that’s not a typo in the word eligiblity!)
Done. Close the command prompt window."
Up to there is great but there is one command missing.
Switch back to the Config#
and then type "save"
it will write the changes just made to flash, thereby saving it. That way when the router powers off and then powers on again the config will be intact. No need to go in and change it every time the router power cycles.
Turn off TR069 protocol in all the places where it's enabled so the router can't be accessed remotely by PLDT's TR069 protocol servers.