Tutorial PLDT HOME DISABLE AP ISOLATION

[FreeAllYouCan-OFFICIAL]

winlo

192.168.1.1/fh

fiberhomesuperadmin
sfuhgu

 

[SimplyTheBest]

permanent po solution diyan, yung tutorial sa taas temporary po yan.

sir pano po ung permanent? nawawala kc ung config pag narestart ang router.

 

[FreeAllYouCan-OFFICIAL]

sir pano po ung permanent? nawawala kc ung config pag narestart ang router.

ρáíd po

 

[SimplyTheBest]

ρáíd po

ok na po, nagawa ko na permanent.

 

[soheilsh]

boss paano ba gumawa ng smurf account jan sa pubg?

 

[Bagsik2015]

ok na po, nagawa ko na permanent.

idol pabulong naman pano mo na permanent disable yung AP isolation?

 

[FreeAllYouCan-OFFICIAL]

idol pabulong naman pano mo na permanent disable yung AP isolation?

nasa YøùTùbé gumagamit ng esp module.

 

[PHC-X]

How to "Switch back to the Config#
and then type "save"?

All here might benefit from this..

"

• Type control port_fw_eligiblity_switch disable and press Enter (no that’s not a typo in the word eligiblity!)
• Done. Close the command prompt window."

Up to there is great but there is one command missing.
Switch back to the Config#
and then type "save"
it will write the changes just made to flash, thereby saving it. That way when the router powers off and then powers on again the config will be intact. No need to go in and change it every time the router power cycles.

Turn off TR069 protocol in all the places where it's enabled so the router can't be accessed remotely by PLDT's TR069 protocol servers.

You're welcome

 

[Bootloader1zx]

All here might benefit from this..

"

• Type control port_fw_eligiblity_switch disable and press Enter (no that’s not a typo in the word eligiblity!)
• Done. Close the command prompt window."

Up to there is great but there is one command missing.
Switch back to the Config#
and then type "save"
it will write the changes just made to flash, thereby saving it. That way when the router powers off and then powers on again the config will be intact. No need to go in and change it every time the router power cycles.

Turn off TR069 protocol in all the places where it's enabled so the router can't be accessed remotely by PLDT's TR069 protocol servers.

You're welcome

WOAH, thanks a lot, i'd learn a lot! grabe yun lang pala yun, ayaw ko pa naman bumili ng usb ap isolation para sa repeater ko

 

[maxlaroga24]

bakit d ako nakaka pasok sa 192.168.1.1/fh?

 

[geek492]

Thanks for the helpful tutorial!