Hello! I'm here to help you with your Epson L3110 printer issue. If your printer is still blinking red and yellow lights even after resetting the ink pad using adjprog, there are a few more steps you can try to resolve the problem:
1. Check Ink Levels: Make sure that all the ink cartridges are properly installed and have sufficient ink levels. If any cartridge is empty or low on ink, replace it with a new one.
2. Check for Paper Jams: Open the printer cover and check for any paper jams or obstructions. Clear any paper jams and close the cover properly.
3. Restart the Printer: Turn off the printer, unplug it from the power source, wait for a few minutes, and then plug it back in. Turn on the printer and check if the lights are still blinking.
4. Update or Reinstall Drivers: Sometimes, outdated or corrupt printer drivers can cause issues. Try updating the printer drivers on your computer or reinstalling them.
5. Perform a Power Reset: Unplug the power cord from the printer while it is turned on. Wait for a few minutes, then plug the power cord back in and turn on the printer.
If after trying these steps the issue persists, it is possible that there may be a hardware problem with the printer. In this case, it is recommended to contact Epson customer support or take the printer to a service center for further assistance.
I hope these suggestions help resolve the issue with your printer. Good luck, and feel free to ask if you have any more questions!