Kaya ang ginagawa ko ako na mismo pumupunta sa tower ehSad di updated sa cellmapper ung lugar ng cellsite na nakukuhanan ko ng signal
Choose a valid VLAN number.
Choose a private IP address range for devices on that VLAN to use.
Configure the switch device with either static or dynamic settings. In static configurations, the administrator assigns a VLAN number to each switch port. In dynamic configurations, the administrator assigns a list of MAC addresses or usernames to a VLAN number.
Configure routing between VLANs as needed. Configuring two or more VLANs to communicate with each other requires the use of either a VLAN-aware router or a Layer 3 switch.
The administrative tools and interfaces used vary depending on the equipment involved.
San ba nkikita yon?Kaya ang ginagawa ko ako na mismo pumupunta sa tower eh
Ang alin papsSan ba nkikita yon?
Ung mga nkakabit na band sa tower? Bago lng kase tower dito .pinalitan ung phase out na towerAng alin paps
Gamit ka cellmapper lods. May tab dun na makikita mo yung info (cell id, bands, etc.) about sa tower kung saan ka naka konek.Ung mga nkakabit na band sa tower? Bago lng kase tower dito .pinalitan ung phase out na tower
un nga paps problema ung kinokonekan ko n mga band wala dun sa cellmapperGamit ka cellmapper lods. May tab dun na makikita mo yung info (cell id, bands, etc.) about sa tower kung saan ka naka konek.
na try mo naba mag tower search?un nga paps problema ung kinokonekan ko n mga band wala dun sa cellmapper
Di ko sure eh. Feel ko auto reset naman siguro sya pag wala na yung towersalamat dito boss...tanong ko lang...incase kung nalock mo sa isang tower for example sa city...tas lumipat kau ng area like sa province...auto ba sya mg rereset?o nakalock pa din sya sa nalock mo na cell tower