What's new

Closed Free energy

Status
Not open for further replies.

Ashirous

Addict
Joined
Jul 11, 2017
Posts
134
Reaction
67
Points
115
An answer to some question about the Bedini SSG motor.

One must understand the theory of what the device attempts to perform.
The first thing we all must understand is the term Free Energy since everyone
building these device thinks it’s some kind of magical machine in a way it is
as it does some things that are not found in the common text.What you have built here is an Energizer,
Energizers perform two things, Motor functions and generator functions all
within the same machine. The Motor function is not designed to be self-starting
because it must set on the primary battery for use without any input current
until it starts. The motor section must be pulsed to draw very little current
you must think of this as someone on a swing where you only give a little tap
to keep them swinging and then they go over the top, so it take very little
energy. The second stage is a generator functions without any Lenz effect or
very little, meaning no counter EMF force. We are dealing with two different
types of energy the machine is
outputting.The Motor section uses
electrons or real current from the battery and the second uses or generates no
real current with electrons.You can
prove it by using a .5 ohm resistor across the output in place of the secondary
battery.Since your meter cannot measure
this because of the spikes you must convert it so that you can measure it the
capacitor is the answer because it can convert the spikes into real usable
power that uses electrons so normal circuits may be powered.

The most important part of the machine is the mechanical energy that
people do not use. That energy is around 23 to 40% so that must be added into
your figure when figuring the efficiency of the machine.If you notice by placing a load on the mechanical
output the current on the primary side will go down since we have no closed
flux path like a normal motor. Work performed under load without an increase in
input current means efficiency, conservation of energy.All energy changes form at some point and is
never lost you just must figure a way to use what it was converted to_Others have made the error of saying that the
COP of 10 to 1, not true as I only look for a COP of 1 or a 100% percent
conversion factor In the chemical reaction (The Battery}.

Radiant energy can be anything
it just does not apply to heat as the universe is filled with it in many
forms.If you have one battery and can
charge it with that change in energy why not add more batteries to the output
that is where the 10 to 1 comes from, and yes it is possible to do that since
you’re not dealing with normal electron current or very little. So how do we
get real power from the machine?What
you have built here is a repulsive motor function meaning the magnet is being
kicked out, that takes power and you will lose some energy doing that so let’s
think along different lines like re-gauging the motor coil function.

Let me say something here now about magnets do not use Neo magnets as
it will change the function of the Energizer and you will lose power output you
must keep from saturating the core material which must not retain its
Magnetism that is why the use of welding
rod.Bolts do not work well for this
machine or ferrite cores. The Coil must be done very carefully and with the
correct amount of turn’s number 21 wires along with a number 23 for the
trigger, wires wound together for your experiment.The next thing is the base resistor which
must be chosen for the least amount of current 470 ohms would be the starting
point with a 22 Ohm pot for fine adjustment.If you free up the base current the machine will speed up for the most
generated spiked currentless output. The coil acts like a varying electromagnet
where the Bloch wall moves to act as an energy pump so energy is sucked in and
compressed to give the high voltage which is a gain function of the inverted
amplifier circuit since we use the collector circuit and not the emitter of the
device. Back EMF does not apply to this circuit as Back EMF is always lower
than the battery voltage. Keep the current out of the circuit and the Radiant
high voltage will gain in potential.If
you apply a potential to batteries they will try to move up in voltage and they
do that as the Ions gain charge and start to move to the next plate in the
battery. You want to move them without work and this machine does that by
building charge on the Ions in the battery, works like a sail boat but without
the electrical wind of the machine nothing moves. The high potential causes
this to happen, plain physics; the idea is the use of currentless energy, just
potential charge.

Ok, back to how to get the power, first flip the coil so the machine
runs in attraction instead of repulsion, why? Because you do not want to do any
work or waste energy pushing the wheel you want the wheel to be sucked in for
free and have the coil re-gauge the energy for nothing.Next you need to apply a Beta multiplier
filter circuit to the output of the diode that is zener controlled to no more
than 30 volts that is going to filter all the spikes before they go to the
capacitor of your choice, I would use between 4700 to 10000 uf at 75 volts for
this. Next choose some type of linear regulator like a LM7805, 5 volts is the
output this would give the proper current for charging your cell phone battery
and will limit at 5 volts, the battery will do the rest.You cannot have any spikes on lithium
batteries, lead acid does not care be very careful with alkaline batteries. Now
think all you do is multiply the coils and the simple circuit for bigger
batteries and your off and running.No
free energy here just gathering all the normally wasted energy in a circuit and
using a conversion method to gain energy to power normal loads.Again the term free energy is an energy that
cannot be measured with normal meters so people think they discovered
something. We must pay for everything we do so why not just try to get as close
to a COP of 1 as we can. People love the term free energy so the unexplained is
classified and this calls out all the skeptics who believe the world is flat
anyway so why argue with any of them since they know everything.Just build the machine and discover science
for yourself since there is no absolutes’ in science anyway. We really know
nothing only what we have been taught but we really know nothing except what we
can prove. Nature is full of hidden secrets yet to be discovered.

You can find more advanced circuits by me and books and videos along
with Tom Bearden’s work on the internet if you search you may even find a
linear circuit people have made. The knowledge is out there you just need to
look. And do not believe everything you read.

THE MACHINE IS LIMITED

I’m not allowed to say anymore
then this except some of the SSG machines have been taken away from people. I’m
not going to go into the reasons but if you discover anything over the figures
I have stated here then it is considered a national security risk, and we all
know what that means.My patent is very
limited and only has the claims the big boys would allow. Right now you have a
few people discouraging your work on this project you can tell by the comments.
This is why you do not want to argue with the skeptics as they will try and
tell you to just use normal things and do not look outside of the box for any
answers.Again your free to experiment
with any of the circuits that were posted on the internet.

Nature is very simple in the way she acts and is very tricky in her
secrets.

Courtesy to.
Tom bearden
Jhon bedini
 
Ikaw na nagsabi na delekado, tapos gusto mo mga ordinaryong tao maging involve? Flawed statement.

Kung mga bees lang sana tayo at nagkaroon nang hivemind, edi sana utopia na tayo. Pero eto na cguro yung limit nang pag evolve nang human consciousness, time is ticking and a big reset is coming.
 
Status
Not open for further replies.

Similar threads

Back
Top