What's new

Trivia Cisco CCNA Packet Tracer Ultimate Labs: CCNA Exam Prep Labs Part 1 & Part 2

mas18ram

Forum Master
Joined
Sep 10, 2018
Posts
597
Reaction
45,582
Points
5,149
-Labs-CCNA-Exam-Preparation-Labs-Part-1-2-Download.jpg

Cisco CCNA Packet Tracer Ultimate Labs: CCNA Exam Preparation Labs Part 1

ISBN: 13 9781838646370

Course Length: 12 hours 40 minutes

MP4 | Video: AVC 1920x1080 | Audio: AAC 48KHz 2ch | Duration: 12 hours 40 minutes

Genre: eLearning | Language: English | Size: 2.73 GB


Get the hands-on experience to pass your CCNA exam! Make sure you are ready to pass the CCNA exam! Prepare practically for the Cisco CCNA certification which is the most in-demand networking certification in the world today! Make sure you can pass the Cisco CCNA Routing and Switching 200-125 exam! This course tests your knowledge of CCNA topics with practical, hands-on labs. Labs include both configurations as well as troubleshooting labs.
Start your journey today learning about networking.

  • Section 2 - Download, Installation, and Introduction to Cisco Packet Tracer

  • Section 3 - Basic Cisco Configuration Lab covering configurin host names, IP addresses, creating and encrypting an enable password, configuring the lines, ensuring basic connectivity between two routers, as well as telnet access

  • Section 4 - Life of a Packet Quiz - Uses Packet Tracer's Simulation Mode to gather the information necessary to answer the quiz questions listed in the topology diagram. It shows what changes are made to a packet from source to destination as it's processed by L2 and L3 devices, as well as changes between L2 data-link encapsulated frame types.

  • Section 5 and 6 - Subnetting Lab 1 - Subnet an intial IPv4 allocation to support 4 smaller subnets, configure the routers, switches, and DHCP servers per the instructions, as well as testing client PC connectivity to remote web servers.

  • Section 7 and 8- DHCP Server Lab 1 - Configure a DHCP server on a router, and test with a PC. (single VLAN)

  • Section 9 - Router on a stick - Configure a router to perform inter-VLAN routing for clients connected to a switch. Tasks include configuring subinterfaces on the router, creating VLANs on the switch (along with a single SVI), establish a trunk between the router and switch, and confirm connectivity with client PCs.

  • Section 10 - Broadcast and Collision Domains - A quiz lab, where you gather information by using Packet Tracer's sumulation mode, to correctly answer the questions. Covers ARP, Broadcast Domains, Collision Domains, differences between Hubs and Switches.

  • Section 11 - Basic VLANs in a Campus Network - Covers Intervlan routing, creating multiple VLANs and SVIs, configuring trunk links and access ports appropriately.

  • Section 12 - VTP Configuration Lab - Covers VTP options and configuration, including password, domain name, and operational modes.

  • Section 13 - VTP Troubleshooting Lab - Example network has issues with VTP clients not synchronizing their vlan databases to the VTP server. Students must investigate and correct multiple problems.

  • Section 14 - Disable Spanning-tree? - Students use Packet Tracer's simulation mode to see what occurs when disabling STP on two switches connected by two links (L2 loop is induced on purpose, to reinforce the importance of STP on switched networks.

Style and Approach
An exhaustive course packed with step-by-step instructions, working examples, and helpful advice. This course is divided into clear chunks so you can learn at your own pace and focus on your own area of interest

Cisco CCNA Packet Tracer Ultimate Labs: CCNA Exam Preparation Labs Part 2

MP4 | Video: AVC 1920x1080 | Audio: AAC 48KHz 2ch | Duration: 8h 37m

Genre: eLearning | Language: English | Size: 1.91 GB


Join this in-demand industry! Start your journey today learning about networking. I want to welcome you to this Cisco CCNA Packet Tracer Ultimate labs course! I’m David Bombal, and I have been teaching networking courses for over 15 years. The course covers the topics in the Cisco ICND1, ICND2 and CCNA exams. At the end of this course, you will be able to confidently discuss networking topics; and be able to start configuring real networking devices such as routers and switches. In this an introductory course, but contains a lot of information that can be directly applied to the CCNA certification. There are no requirements necessary to enroll in this course, I only ask that you come open-minded and ready to learn.

What You Will Learn

  • Be prepared for the CCNA exam

  • Verify your knowledge of CCNA exam topics

  • Ace the CCNA Exam simulations

  • Pass the CCNA or CCENT exams


Table of Contents Part 2

  • Local SPAN

  • Remote SPAN

  • Static Routes

  • RIP

  • RIP Routing Lab 2

  • EIGRP Configuration Lab

  • EIGRP Troubleshooting Lab 1

  • EIGRP Troubleshooting Lab 2

  • EIGRP Troubleshooting Lab 3

  • EIGRP Troubleshooting Lab 4

  • EIGRP Troubleshooting Lab 5

  • OSPF Single Area Lab

  • OSPF Multiple Area Lab

  • OSPF Troubleshooting Lab 1

  • OSPF Troubleshooting Lab 2

  • OSPF Troubleshooting Lab 3

  • BGP Configuration Lab

  • BGP Troubleshooting Lab 1

  • BGP Troubleshooting Lab 2

  • BGP Troubleshooting Lab 3

  • BGP Troubleshooting Lab 4

  • BGP Multihomed Network

  • IPv6 Configuration Lab

  • IPv6 Troubleshooting Lab

  • OSPFv3 IPv6 Lab

  • GRE Tunnel

  • PPP & PPP CHAP

  • Quality of Service (QoS)

  • VoIP: CUCME and Cisco IP Phones

Links for Part 1:

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

Links for Part 2:

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

You do not have permission to view the full content of this post. Log in or register now.

Password = bitdownload.ir
 

Attachments

thanks for sharing lods. gusto ko sana matuto lods pwede na po ba ito maging reference ko para matuto ng cisco or guide lang po to lods ?
 

Similar threads

Back
Top